Complete thread:

• The piston length isn't correct » chevell on Feb/27/2007 at 02:57PM View Thread
  • Maybe you can just » chevell on Feb/28/2007 at 07:45PM
  • Your piston seal end will not be remove from lathe until » Ratite on Mar/01/2007 at 02:47PM
    • .618 » chevell on Mar/01/2007 at 07:55PM
      • Ok then its done » Ratite on Mar/01/2007 at 09:27PM
        • Now thats what I call » chevell on Mar/02/2007 at 10:07AM
          • YUP blue Loctite small heat will do it nt » Ratite on Mar/02/2007 at 01:11PM
            • Are you ready to mail that piston half? » chevell on Mar/06/2007 at 04:34PM
              • piston went out on the 6th nt » Ratite on Mar/10/2007 at 07:42PM