Drill and tap

Posted by - chevell Dec/15/2006 at 03:56PM

Maybe I didn't see how it was held together in the picture. I'll wager a guess and say that the drilling and tapping needs to be in the exact center of the piston, and the odds against me doing that without a lathe are slim to none, so I might need to have you do that for me,or maybe, just make me another piston that is set up for the new type seal-O-ring combo. The piston I made for my 1322 works ok but a much better one can be made on a lathe. So if you can maybe mod one of your other pistons to work or something that would be good. What ever it costs just let me know,I pay my bills!

Send the tube? Do mean send the stainless tube I honed for this next project?
I can use the valve as a guide to get me the final demensions on the ID of that tube,I would say it's very close to stock size,maybe a hair under,were talking tenths here. My valve is .617 and it's not tight but very close. For the piston OD .6185 at the most. But since I don't want the piston touching the tubing, the OD at the O-ring end can be .6185 but above that it should be .610,rememeber that the shrink teflon fills in what ever space is left over so the piston OD above the O-rings doesn't need to be .6185. Thanks for the help.

---